FRP tiles (panels) products are widely used in industrial plants, warehouses, greenhouses, stations, docks, airports, sports buildings, commercial buildings, steel structures and many other lighting areas.
Points to note for installation of FRP lighting tiles.
1, after laying, set aside the location of the light panels, construction by the eaves gradually to the ridge direction. Light panels are directly buckled on the side crest of the steel plate.
2, light tile in the fixed before the first guide hole, the aperture must be greater than the diameter of the fixing screw 6-9mm, in order to be used for thermal expansion and contraction.
3、Light tile and steel plate in the longitudinal lap, the minimum must have 200mm overlap, and affix two water stops.
4, light tile fixed, must use a good flood gasket, so that between the screws and light plate, in order to facilitate the waterproof and dustproof.
5、After the flooding gasket is set into the screw, use the electric drill to lock into the purlin, that is, to complete the work of fixing the light board.
6、Light tile construction, strictly forbid feet directly on the crest, so as to avoid cracking of the light board. Must be placed in the horizontal position of the light board, a 1200mmx300mm {length x width) non-slip thick wooden board, foot on it for the light board guide hole and fixed screw work.

Product characteristics
1. Weather-resistant, not easy to aging, cold not brittle hot not soft, long-term use environment temperature -40 ℃ ~ 120 ℃.
2. Heat insulation, good thermal insulation effect (thermal conductivity 0.14kcl/mhr degree Celsius)
3. non-toxic, no formaldehyde, no carcinogenic microbial hazards such as asbestos, in line with world health standards
4. no moss, prevent the growth of microbial adhesion under the correct construction, strong wind resistance (can resist 120 miles per hour strong wind), glass fiber reinforced plastic inside the shatter-resistant and strong impact resistance, can block the impact of wind, snow and hail, to avoid causing nail hole expansion and leakage.
5. Light weight and high strength, relative density between 1.3g/cm³~1.5g/cm³, the weight is only 1/4~1/5 of carbon steel, but the tensile strength is close to or even exceeds that of hardened steel, while the strength can be compared with alloy steel. Impact resistance, even if the wheels run over can be restored to its original state (deep drawing strength of 75Mpa).
6. The light is diffused, soft light, high light transmission rate, can effectively block most of the ultraviolet rays in the event of fire, rapid combustion will be indoor smoke exhaust, can reduce fire casualties, and in the burning process does not produce molten droplets, can effectively protect the safety of the site personnel.
7. Light tile is easy to clean, easy to clean, no special care.
It has the characteristics of continuous molding, infinite extension, aging resistance, light transmission, flame retardant, precise size, smooth surface, random coloring, maintenance-free, green environment protection, etc.

The company is mainly engaged in the development, production and sales of FRP products. It is an enterprise specializing in the production and sales of FRP pipes, containers, FRP sheet products, composite insulating materials, electrical composite materials, light weight composite materials, rainwater collection and treatment equipment, etc. The company has 2 FRP pipe winding production lines, 2 FRP container production lines, 2 FRP concrete composite pipe casting lines and 1 FRP sheet production line. The products conform to the national energy-saving and environmental protection industrial policy and are widely used and promoted. With the unique advantages of transportation, geography and human resources in De Tian, the company is radiated and driven by Chengde Mian Economic Belt and Mianyang City Economic Circle, and with the modernization of urban and rural agriculture, the company's products have a broad prospect.

Xie Gang

yiko0420@gmail.com

 Online Store